NTS-6001 WEB CONFIGURATION
www.
galsys
.co.uk
galleonsupport
.com
TEL:
+44 (0) 121 608 4433
FAX:
+44 (0) 121 608 4477
NTP TAB
NTP STATUS
This is where you can check the status of the NTP process and see the sources that this process is
synchronised with, including the state of these sources.
The host names or addresses shown in the remote column correspond to the server and peer entries
listed in the configuration file; however, the DNS names might not agree if the names listed are not
the canonical DNS names.
The refid column shows the current source of synchronisation, while the st column reveals the
stratum, t the type (u = unicast, m = multicast, l = local), and poll, the poll interval in seconds.
The when column shows the time since the peer was last heard in seconds, while the reach column
shows the status of the reachability register (see RFC-1305) in octal.
The remaining entries show the latest delay, offset and jitter in milliseconds. Note that in NTP
Version 4, what used to be the dispersion column has been replaced by the jitter column.
The currently selected peer is marked *, while additional peers designated acceptable for
synchronisation, but not currently selected, are . Peers marked * and + are included in the
weighted average computation to set the local clock; the data produced by peers marked with other
symbols are discarded. See the ntpq page for the meaning of these symbols.