English
Gallagher 3E5260 M6000i/M12000i Energizer User Manual
18
Fence Zone 1–6
View the Fence Zone performances by pressing the naviga on bu ons (< or >) un l
the zone indica on arrow is highligh ng the desired fence zone (1–6). The fence
zones voltage, current and alarm informa on is displayed in the same way as the
Energizer output informa on. See
Energizer Output and Alarms
sec on (p.15).
To adjust or turn o
ff
the fence zone alarms, see
Adjus ng/Turning O
ff
Alarms
sec on
(p.16).
Low Ba ery
When viewing a zone, if the ba ery icon is displayed, then the zone device needs a
ba ery replacement.
Controller showing the output voltage being adjusted
Adjus ng the energizer output voltage
a)
Press the setup bu on (
) to enter setup mode and use the naviga on
bu ons (< or >) to highlight the quickscan bargraph display (it will start
fl
ashing).
b)
Press (+ or -) to adjust the output voltage up or down. The output voltage can
be adjusted from 4.5KV to 8KV. The factory default se ng is 8KV.
c)
To exit the setup mode wait 10 seconds or press the setup bu on (
).
Controller showing zone 2 with a low ba ery