5. Now hold the wire tightly and then secure it with a
Vidoflex wire connector.
6. Now cut off any excess wire right behind the sealed
Vidoflex wire connector.
Important!
For correct operation of the Plus/Minus system, the
upper and lower wires must not be connected or touched. It
’s
also important that the wires be not in direct contact with the
fence or any surrounding bushes, trees, etc. This will
considerably limit the working of the electrical system.
Step 5 – Connecting the Plus and Minus wire fence
For a good and stable connection of your Plus/Minus fence, we recommend the use of the specially suited
Gallagher ground cable (see step 1, required materials).
Proceed as following:
Connecting the Minus (ground) cable
1. Strip or cut off approximately 35 mm from the insulation layer of the
Gallagher ground cable (Y).
2. Remove the cover plate from the Vidoflex connector (H) on wire D1
by removing the 2 nuts.
3. Then place the stripped part of the ground cable (Y1) in the lower
hollow part of the Vidoflex connector.
4. Replace the lock plate and the nuts of the Vidoflex connector and
tighten the 2 nuts again.
5. Then roll out the desired length of the ground cable to the place
where the electric fence device will be attached, making sure that
there is enough space left to attach the end of the cable to the
electric fence device.
6. Then cut the cable to the desired length and strip or cut
approximately 35 mm of the insulation layer from the end of the
mounted ground cable.
The cable can be attached to the fence or to the wall with the appropriate cable hoists. Such cable hoists or
cable clamps are available at your local hardware store.
Connecting the Plus (ground) cable
To connect the Plus wire, repeat the steps 1 to 4 above (!).