7
7. Attach the headphone hanger to the inside left leg about
midpoint near the front edge of leg. Remove adhesive
backing on the bracket and insert the two (2) small wood
screws through the bracket. Align tips of screws with
holes and then press bracket into place. Tighten screws
but
as the bracket will crack easily.
8QSDFNSLDQRNH\ERDUGDQGFDUHIXOO\SODFHRQVWDQG7KHSLDQR¶VHGJHVVKRXOGH[WHQG
RYHUWKHVLGHVDSSUR[LPDWHO\´DQGWKHEDFNDERXW´
If you align the top as described,
WKHWRSVKRXOGEDODQFHDQGEHFORVHLQDOLJQPHQWZLWKWKHPRXQWLQJKROHVDQG³/´EUDFNHWV
:KLOHVWHDG\LQJWKHSLDQRORRNXQGHUWKHNH\ERDUGDQGFRQILUPDWOHDVWRQH³/´EUDFNHW
LVLQDOLJQPHQWZLWKWKHSLDQR¶VPRXQWLQJKROH$GMXVWWKHWRSLIQHFHVVDU\,QVHUWDKDQGNQRE
and tighten. Repeat for the remaining (3) mounting holes.
10. Insert sustain pedal cable in socket under the keyboard as marked, route the cable under
the base and insert pedal in the front base cavity.
11. Plug AC cable into plug under the keyboard (marked) observing
of
the previous page.
DO NOT OVERTIGHTEN
'2127/(7*22)7+(3,$12817,/<28.12:,7¶6%$/$1&('217+(67$1'
Safety & Precautions
Unpack all piano stand pieces and hardware prior
to beginning assembly.
You should have the following hardware:
%DJ
´VWHHOZRRGVFUHZV
(4) Hand knob bolts
%ODFN´ZRRGVFUHZV
(4) Plastic caps
%DJ
0HWDO³/´EUDFNHWV
ò´EODFNZRRGVFUHZV
Bag #3
(1) Headphone bracket (plastic)
(2) Small wood screws
Bag #4
(varies)
´VWHHOZRRGVFUHZ
(1) Hand knob bolt
%ODFN´ZRRGVFUHZ
(1)
Plastic cap
(1)
Fuse
EXTRA PARTS
ASSEMBLY
Diagram (1)
Diagram (2)
Diagram (3)
(Read Before Starting)
1. Place pedal base with pedals pointing
up and underside of base facing you.
2. Place left leg on its back edge and
align holes in leg with holes in pedal
EDVH,QVHUWWZR´VWHHOVFUHZV
through leg, tighten and insert
decorative plastic caps.
: The
inside of each leg should have the
back cutout facing inward as well as
have (6) tapped screw holes visible
QHDUWKHWRSIRU³/´EUDFNHWV
3. Repeat above for right leg.
$WWDFKWZR³/´EUDFNHWV
to the top
inside of each leg using three (3)
ò´EODFNZRRGVFUHZVIRUHDFK
bracket.
5. Fit the modesty panel to the back of
the base between the legs aligning
the pre-tapped holes ith the bottom
and sides. Attach with seven (7)
EODFN´ZRRGVFUHZV
6. Carefully stand base up.
Note