Attaching feet to your subwoofer
Your 3090 subwoofer comes with feet and spikes which should be fitted as outlined
below.
The spikes attach to the bottom of the feet (as shown below left).
There are eight pilot holes on the bottom of the speakers. The feet are located and
secured here with the wood screws supplied (below right). Level as required.
Connecting via Line Input
Connecting via High Level Connections
If your amplification system has a dedicated subwoofer line output then you should
connect your 3090 via the Line Input on the rear panel using a good quality phono
lead. Note that if your amplification system has a mono subwoofer line out then use
the Left/Mono socket on your 3090.
Connecting via High Level Connections
Do not compromise the performance of your system by using inferior quality cables!
Gale recommends that high quality cables of 16 gauge or higher be used. Your
professional dealer will give you good advice.
Observing polarity is of the utmost importance while connecting your loudspeakers.
Ensure that the red (+) terminals on your amplification system are connected to the
red (+) on the subwoofer, and black (-) on your amplification system to black (-) on
your subwoofer.
Important Note: Always unplug all A.C. powered components before making any
loudspeaker or component connections. This will avoid the risk of electric shock or
damage to your equipment.
Running In
Your new unit will require a total of approximately 10 hours of normal use to allow
the components to settle into their working routine and reach their optimum
performance.
8
Getting Started
Fig. 3
Fig. 4
AP134793 (Koda) Gale 3090 Owners’ Manual.qxd 22/04/2003 15:00 Page 8
