Pairing the remote control for up to 5 blinds
The blind has been pre-programmed to Channel 1 on the remote control (as illuminated on the channel
indicator). Up to 4 additional blinds can be programmed to the same remote control by following these
steps.
NOTE:
You have 10 seconds to pair each blind before the remote control resets and you will need to start
the sequence again.
Setting an additional stop position
The blind has been pre-programmed with top and bottom limit positions.
To set an additional stop position, follow these steps.
1.
Hold motor program
button for 3 seconds.
2.
Press channel
selector button to
choose the desired
channel for pairing.
3.
Press the remote
control program button
once. Motor will beep
once and rotate (back and
forth). When the motor
stops press it again.
4.
Press the up
button once.
Motor will beep once and
rotate (back and forth).
Motor will reverse
and beep six times to
complete the pairing.
Repeat the above steps to pair additional blinds to the remote control.
Once all blinds have been programmed to the remote they can be operated independently or all at the
same time. Press the channel selector button to choose a single blind (1 to 5), or, when all 5 channels are
illuminated all blinds will operate together.
+
Channel
selector
button
Channel
indicator
+
Program
button
+
Up
button
1.
Select the desired
additional blind position
using the up, down and
stop buttons on the
remote control.
2.
When the blind is in
the desired position,
press the program
button on the back of
the remote.
3.
Press the stop
button once.
4.
Press the stop
button one last time.
Motor will beep
once and rotate
(back and forth).
Motor will beep 3 times,
signaling that the
additional position is set.
+
Program
button
+
Up
button
+
Down
button
Stop
button
Up
button
Motor will beep
once and rotate
(back and forth).
+
Stop
button
