08
07
Disassembling and Cleaning Method
Disassembling and Cleaning Method
Depending on the product model, the actual product's color may be different.
Depending on the product model, the actual product's color may be different.
After placing the operation switch on “stop”,
unplug the cord.
From the container, disassemble the rotation
wiper, strainer, and screw. After disassem-
bling each parts in the reverse order of
assembling, wash with a soft brush.
After turning the container lid in counter-
clockwise direction, disassemble by pulling
up the drum lid.
After turning the juicing bowl set in
counterclockwise direction, disassemble by
pulling up the juicing bowl set.
Clean the main body by wiping it with a soft,
lightly moistened cloth.
Caution
Caution
Stop after all of the juicing bowl set is
eliminated of the pulp.
Please be aware that if you do not immediately wash
after usage, debris will dry off and not only make
disassemble and cleaning hard, but also becomes the
cause of decrease in operation efficiency.
Caution
If the squeezed silicon and the silicon ring are not completely fitted
in, the juice amount may be little or the juice may seep out.
Caution
If the washing cloth has much moisture, be sure
to remove the excessive water by squeezing the
towel out well before wiping.
The juicing bowl set disassembling can be easily
disassembled in the sink by letting tap water flow from
top to bottom.
Dry off well so that the inner side of the metal part in the
screw shaft does not have any moisture.
Depending on the ingredient, if opening the lid is
difficult, repeat 2~3 times of reverse ↔ stop ↔
forward rotation and then firmly press the drum lid’s
top side with the palm of your hand and open by
turning.
For convenient washing, after the juicing
is completed, run it for about 30 seconds.
Depending on the ingredient, insert water
into the slot as a quick washing, and then
turn the lid.
※
Clean the rotating wiper under running water.
Always use it when it is dried after washing. Before assembling the juicing bowl set,
be sure to check if the squeezed silicon and silicon ring is correctly fitted in.
Assembling After Washing Silicon Brush
Assembling After Washing Squeezed Silicon
Assembling After Washing Silicon Ring
<Silicon Brush>
Separate washing is possible.
After washing, point the silicon brush’s
tail part in the downward direction, and
as shown in the picture, place in the
middle wide space and fit in the order of
down → up and then use.
<Squeezed Silicon>
Can be opened and then washed.
After washing as shown in the picture,
place it in the direction of the arrow and
then use.
<Silicon Ring>
Separate washing is possible.
After washing, fit in the silicon ring in the
home accurately by having the wide
surface in the upper direction as shown
in the picture.