Galaxy GS-202, Operation Manual

Page: 9 / 11

9
Adjusting the Pressure
8. Adjusting the Pressure
Printing And Pressing
9. PRESS

Once you put a blank mug and press down the handle, temperature will fall down
then start to go up because the mug is cold so circuit board shows the real
temperature of the heater so will fall down then go up.

The timer will automatically count down when heater heat up to temperature 2
setting

After a printing cycle, temperature of heater will fall down to the temperature 1
setting.

The time will automatically re-set and you are ready to continue with the next
application.
8.1 Adjust the pressure by turning the
knob clockwise to increase pressure
and counter clockwise to decrease
pressure(fig.5.1).
6.1 Once your equipment has reached
the designated
temperature1,position the blank mug
inside and proceed to press.
6.2 After pressure handle closed, heater
will heat up from temperature1 to
temperature 2, then time starts to
count down to 0 indicating a printing
cycle complete.
if temperature on heater is higher than
circuit board shows,pls lower the Pb
value.
Example:
Heater temperature:160C
Circuit board temperature:150C
Pls set Pb Value at ( -5 to -10 )
Please note: small Pb value adjustment
will bring temperature calibration in large
range. So suggest change Pb value
carefully in small range.
if temperature on heat platen is lower
than circuit board shows,pls raise the Pb
value.
Example:
Heat platen temperature:160C
Circuit board temperature:170C
Pls set Pb Value at ( +5 to +10)
Please note: small Pb value adjustment
will bring temperature calibration in large
range. So suggest change Pb value
carefully in small range.