background image

 

 

WARRANTY 

This radio is covered by a two
year Limited parts and labor
warranty

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

“Limited” means that we will repair problems caused by factory defects or normal 

use at no charge. 

 
 
 

 

 

Before returning a radio to us for warranty service, please call our Service 

Department for a Repair Authorization Number (RAN). This RAN must be written 
below your return address on the outside of the shipping box. Boxes, which arrive 
without an RAN, will be refused, and the shipping company will return the 
unopened box to you. Be sure to have a pen and paper ready along with the serial 
number of your radio before calling. We will give you the RAN and our shipping 
address over the phone. The telephone number of the Service Department is (760) 
480-8800, and we suggest calling between 10:00 AM and 4:00 PM Pacific Time. 

 

 

Please include a note with a detailed description of the symptoms. This is important 

because it will help the technician who works on your radio to locate your problem. 
Intermittent problems are easily overlooked, so be sure to give as much detail as 
possible in your note. Also, please include your daytime telephone number in case 
our technicians have any additional questions. 

 

 

Do not send your power cord or microphone unless we ask for these items during 

our telephone conversation. 

 

 

You are responsible for getting the radio safely to us. (We suggest using United 

Parcel Service.) You must pay to ship the radio to us, and we will pay to ship the 
radio back to you. Since we use UPS and they do not ship to Post Offices boxes, 
please provide us with a street address for the return of your radio. 

 

 

We will repair and return your radio as soon as we can. We appreciate your 

choosing a Galaxy radio and we want you to be on the air as much as possible! 

 
 

Be sure to visit our web site at 

 

www.GalaxyRadios.com

 

   

 

 

19

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
               

 
 
 
 
 

Printed in Taiwan 

AT0949010P 

 

 

18

Summary of Contents for DX 95T











Reviews: