- 6 -
User Manual
Troubleshooting
Problem
Causes
Solution
Indicator light will not turn on and
unit will not heat.
Plug not properly in-
serted.
Reinsert plug.
Micro-switch not closed.
Adjust the limit distance of mircro-switch.
Heating indicator is not on, the
temperature is not increasing.
Electric heater tubes is
not properly connected.
Tighten both sides of electric heater.
Heater is defective.
Change electric heating tube.
Power indicator is on but the desired
temperature is not reached.
Temperature controller is
burned out.
Change temperature.
Temperature control is normal but
indicator is not on.
Indicator light is burned
out.
Change indicator.
Temperature indicator is on, but
heater tube is not hot.
Temperature limiter has
tripped.
Reset over heating protecting button by hand on
bottom of electrical box.
Temperature can not be controlled.
Temperature limiter is out
of order.
Change temperature limiter.
Troubles listed are for reference. If any fault occurs, please discontinue use. Do not attempt to repair
yourself. This will void the warranty.
Transportation and Storage
During transportation, the machine should be careful handled by using the handles at the sides of the unit. The pack-
aged machine should not be stored in the open. It should be put in a ventilated warehouse without corrosive atmo-
sphere and placed right side up.
Daily Check
Before Using
• Make sure machine is on level surface.
• Check to see if power cord is frayed or damaged.
During Use
• Check control panel for damage.
• Check for any electrical smells.
• Check for any strange sounds coming out of machine
• Watch for oil spattering.
