4
RM10
Phantom Power:
Two Phantom Power Switches control the 48Vdc Phantom
Power on Channels 1 through 8. Phantom Power Switch one
controls Phantom Power for Channels 1 through 4 and Phantom
Power Switch two controls Phantom Power for Channels 5
through 8. Phantom Power is supplied to the Phoenix Block
connectors when the Phantom Power switch is in the “In
Position”. If Phantom Power is not required the Phantom Power
Switch should be in the “Out Position”.
Volume Controls:
Volume controls, which correspond to channels 1 though 10 are
located on the front of the RM10. Channels 1 through 8 also
feature Pad Switches located on the back of the unit below each
channels input jack. Pad switches will reduce the gain by –20dB
to accommodate very strong input signals. The Pads are
engaged when the switches are in the in position. Optimum
performance is obtained when the when the Volume Controls
can be set generally in the middle of their range rather than at
the extreme MIN or MAX.
Output Section:
Various Output jacks are located on the back of the unit. The
mix created with the 10 input Volume controls will appear at all
Output jacks. A balanced microphone level output is present at
the Phoenix Block labeled “Mic Out” and a balanced line level
output is present at the Phoenix Block & ¼" jack labeled “Line
Out”.