Galaxy Audio G-1200, User Manual, Page: 10 / 16

INPUTS
Each channel has (1) balanced XLRF and (1) balanced TRS ¼" input connector. These
can receive balanced or unbalanced line level signals.
LINK
The XLRF and TRS ¼" channel connectors are wired in parallel to facilitate daisy chaining
of channels.
OUTPUTS
Twist-Lock connectors (minimum impedance 4ohm).
The Twist-Lock connectors are wired: PIN 1+ positive signal, PIN 1- negative signal.
BRIDGE OUTPUT Twist-Lock connector (minimum impedance 8ohm). PIN 1+ power
output signal positive PIN 1- power output signal negative
NOTE: to avoid possible damage to the loudspeaker enclosures, only connect enclosures or speaker
systems compatible with the power load and impedance limits indicated for the amplifier (regarding this,
consult the "Specifications" chapter for reference to your specific amplifier model). Use only stranded twisted
pair minimum 18 gauge cables.
AC
Attached power cable
FUSE
Holder for fixing power fuse
Note: replaced with the same fuse or reference the manual.
STEREO/BRIDGE
This slide switch is for selecting amplifier configuration. In the stereo position it has two
independent channels. In the bridge position the channels are combined to form a single
channel amplifier of greater power. In the bridge mode the minimum impedance load
should be no less 8ohms.
GND switch
This slide switch is used for connecting the input Pin 1 to either circuit ground or chassis
ground, this can be useful in eliminating ground loops between the amplifier and other
active devices.
REAR PANEL
6