a magnetron, the
lustre at
be polished with a sand paper (FIG.4 -7).
2.
the
of the magnetron antenna to the hole of the wave
housing, tighten the four screws of the
magnetron
and
tighten the screws of the lampshade (FIG.4 - 8).
3.
in the
terminals of the magnetron filament and the thermal cutout.
4.5 THE
Firstly, do as the 1,2,3, steps at III of this
Dismantling steps for the transformer: (as FIG.4 -9).
out
the terminal of the transformer.
2. Turn the microwave over.
3. Take
the right baseboard with the transformer
loosened the four
which fix the board on the
oven.
Take off the four screws, a, b, d with
screwdriver.
4.
5. Take off the right baseboard, the seat and the rubber space
the transformer and the oven.
base board
transformer
Fig. 4-10
Fig. 4-9
to mount the transformer,
1. Place the transformer as the FIG.4 - 9, tear off the protective paper of the rubber lining tape, stick it on the
transformer as shown on the figurę. Then put on the seat and the right base board,
the screw
hole
tallied, then tighten the four screws for the high voltage winding is
here.
2. Fix the transformer on the oven as
off the protect paper of the rubber
set it between the
transformer and the oven,
the adhesive side is sticked on the oven.
3.
in all the terminals of the transformer precisely.
THE FAN
Firstly, do as the 1, 2, 3, steps of III of this part.
To
out the two terminal of the fan motor (FIG.
2. According to the FIG.4 -12,
out the
which
marked "A" and "C" from the thermal cutout and the fuse
housing separately, and take off the earthing screw which
marked "B"
3. Take out the power supply cord from the trough as the
figurę shows.
4. Loosen the screws shown on the FIG.4 -13 with a
-
screwdriver, and take off the fan holder.
supply cord
12
