13
14
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Center, please carry out the
checks listed below.
During machine operation, if the appliance stops suddenly it is an indication that the machine is
not working correctly. Refer to the table below and, once the problem has been rectified, press the
Start/Pause button to restart the programme.
Malfunction
Possible Cause
Solution
Dryer does
not work
Mains plug is not plugged in.
Loading door is open.
Have you pressed the button?
Plug in at main socket.
Close loading door.
Press the button again.
Drying results
unsatisfactory
Wrong programme selected.
Filter clogged.
Incorrect volume of laundry.
Sediment on humidity sensor.
Select a different programme the
next time you dry(see "Drying
Programme "section).
Clean lint filter.
Observe recommended loading
volumes.
Drum light does
not work(option)
Light bulb is defective.
Replace light bulb.
Drying cycle ends
shortly after
programme starts.
"END" light
illuminated.
Not enough washing loaded or
washing load is too dry for
selected programme.
Select higher drying level(e. g.
Heavy instead of Strong)
Drying cycle lasts
an unusually long
time
Load volume is too big.
Reduce load volume.
If you are unable to identify or solve the problem contact our service center. Before telephoning,
make a note of the model, serial number and purchase date of your machine: the Service Center
will require this information.
Note: All the following data in the table is based on results tested in according with En61121:2013
standard. This data may vary on products due to the following: different laundry type, residual
moisture, environmental conditions and voltage fluctuation.
IMPORTANT:
If you call out an engineer to a fault listed above, or to repair a fault caused by
incorrect use or installation, a charge will be made even if the appliance is under guarantee.
Technical Data
595
*
555
*
850
7.0
Power(left-on mode)(W)
0
.
78
Power(off mode)(W)
0.72
Energy consuption at full load(kWh)
4.29
Programme time at full load(min)
152.3
5 ~ 35
Ambient Temperature range(°C
)
Procedure
Care must be taken to ensure that the appliance does not stand on the electrical supply cable.
Any electrical work required to install this appliance should be carried out by a qualified
electrician or competent person.
IMPORTANT:
The appliance must not bulit-in.
Unpacking:
All packing must be removed before using the appliance.
Should the appliance be moved, it must be transported vertically.
Check Accessory:
Open the accessory bag and check the accessories.
It is dangerous to alter the specifications or attempt to modify this product in any way.
Earth Note
This appliance must be earthed. In case of failure or damage, earth can provide a minimum
resistance to reduce the possibility of electric shock. The power cord has grounding wire attached to
the plug. The plug must be inserted into a properly installed and grounded socket (in accordance
with all local rules and standards).
Troubleshooting Guide
Summary of Contents for DUK001W
Page 1: ...DUK001W TUMBLE DRYER...
