Gainsborough LINCOLN Installation Manual Download Page 4

Linc inst v2.1 

WARNING THE BATHER REQUIRES THE ASSISTANCE OF A HELPER / CARER 
& SHOULD NOT ATTEMPT TO USE THIS UNIT UNAIDED 

 

WARNING!

  WHEN  USING  THIS  PRODUCT,  BASIC  PRECAUTIONS  SHOULD 

ALWAYS  BE  FOLLOWED.  READ  AND  FOLLOW  ALL  INSTRUCTIONS 
PERTAINING TO RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS.  

 

DANGER

: TO REDUCE THE RISK OF INJURY, DO NOT PERMIT CHILDREN TO USE 

THIS PRODUCT UNLESS THEY ARE CLOSELY SUPERVISED AT ALL TIMES. 
 

WARNING!

 

USE THIS UNIT ONLY FOR ITS INTENDED PURPOSES AS DESCRIBED 

IN THIS MANUAL. 
 
USE ONLY AS INSTRUCTED BY THE MANUFACTURER. RISK OF HYPERTHERMIA 
AND POSSIBLE DROWNING.  
 
THIS PRODUCT IS TO BE FITTED WITH A THERMOSTATIC CONTROL VALVE, SET 
AT A SUITABLE BATHING TEMPERATURE 43° TO AVOID SCALDING. 

Read and follow all instructions 

    

 

DANGER

: To reduce the risk of injury, do not permit children or persons with infirmities to 

use this product unless they are closely supervised at all times. 
 

To avoid injury, exercise care when entering or exiting the Lincoln bath.  
 
Never drop or insert any objects into any openings.  
Always check the underside of the platform for any obstructions before raising the bath. 
 
Risk of electrical shock; connect only to a separate circuit protected by an RCCB 

 

WARNING!

 Risk of electric shock; do not permit electric appliances (such as a hair dryer, lamp, 

telephone, radio or television) within 1.5m of this bath.

 

 

The unit must be connected to a RCCB. Such a circuit is provided by the installer and should be tested 
on a routine basis. To test the RCCB push the test button; the RCCB should interrupt power. Push the 
RESET button; power should be restored. If the RCCB fails to operate in this manner there is a ground 
current flowing, indicating the possibility of an electrical shock. Do not use this unit. Disconnect the unit 
and have the problem corrected by a qualified service representative before any further use.  

 

Risk of electrical shock; spa motors where fitted must be connected to a RCCB protected outlet. 

 

Avoid the abuse of alcohol, drugs, or medication whilst using your Lincoln bath. 
 

 
WARNING! 

 If this unit is to be utilized by many different bathers, we would strongly recommend that it 

is cleaned regularly with a medical disinfectant. 
 
 

CLEANING INFORMATION 

 

The  Lincoln  bath  does  not  require  any  major  maintenance,  but  you  should  follow  these  simple 
instructions. 
 
To clean the bath correctly the backrest & footrest must be removed. 
 
The bath must be in the fully lowered position before lifting the platform (fig 8) 
 

Summary of Contents for LINCOLN
















Reviews: