P
AGE
2 of 14
M
ODEL
TI984 T
ELEPHONE
I
NTERFACE
42004-071F
f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc
05/03
WARNING
This equipment generates, uses, and can radiate radio frequency energy and if not installed and
used in accordance with the instruction manual, may cause interference to radio communications.
It has been tested and found to comply with the limits for a Class “A” computing device pursuant
to Subpart J or Part 15 of the FCC Rules, which are designed to provide reasonable protection
against such interference when operated in a commercial environment. Operation of the
equipment in a residential area is likely to cause interference. If interference occurs, the user, at
their own expense, will be required to take whatever measures are necessary to correct this
interference.
Installation
WARNING
This device can present a 115/230 V ac shock hazard. Please use care when handling this device.
Be sure that the ac power is not connected during wiring.
Site Requirements
The Model TI984 should be mounted near both the GAI-Tronics Page/Party
®
system and the RJ11C
receptacle from the telephone company or Private Branch Exchange (PBX). The distance from the TI984
to one Page/Party
®
station should be such that someone can adjust the controls on the TI984 while
listening to the handset of the station. The distance from the RJ11C receptacle should be less than 14
feet, to allow the use of the supplied plug-in cable.
Note
: If there are no handset stations, contact the GAI-Tronics Field Service Department for instructions
at 800-492-1212, 8 a.m. to 4:30 p.m., Monday through Friday, Eastern Standard Time (EST).
The TI984 should be installed in an environment within the temperature range of 0º C to +70º C
(+32º F to +158º F).
Install the TI984 away from equipment that could cause excessive electrostatic, or electromagnetic
interference, or equipment that produces high voltage.
Wiring Instructions
1.
Remove the front cover by loosening the 4 captive screws and swinging the cover open to the left.
Disconnect the ribbon cable and the telephone cable, and pull the hinges out of the holes in the rear
enclosure.
2.
Determine which of the 4 available conduit locations is to be used. Drill spots have been provided for
use with either a chassis punch or hole saw.
