Pub. 42004-527AQG
HUBBCOM™ GSC1000/GSC2000 Desktop/Wall-Mount Smart Controller Quick Installation Guide
Page 3 of 4
P:\Standard IOMs - Current Release\42004-xxxxQG Quick Guides\42004-527AQG.docx
05/18
Wall Mounting
HUBBCOM
™
Smart Controllers can be wall mounted on a single or
double gang electrical box or directly mounted to a wall surface
using wall anchors or toggle bolts.
Single or double gang electrical box mounting:
1.
Orient the wall-mount bracket (see Figure 3) over the electrical
box with the small flanges on top and the large flanges on the
bottom.
2.
Use #8-32 flathead machine screws (not included) to attach the
mounting bracket to the electrical box using holes A-A for a
double gang (four screws), or B-B for a single gang electrical
box (two screws).
3.
Feed the cable(s) in the electrical box through the mounting
bracket center hole.
4.
Remove and discard the cable termination cover from the back
of the unit.
5.
Remove the two #8 × ½-inch mounting bracket screws from the
bottom of the rear panel and set aside (see Figure 4).
6.
Complete the necessary cable terminations per the instructions in the Wiring section below.
7.
With the proper orientation for the unit’s configuration, angle the unit to hook it onto the top flange brackets (D-D or E-E,
see Figure 4), then rotate and slide it downward until it rests on the mounting bracket.
8.
Secure the unit to the support bracket using the two #8 × ½-inch screws previously removed by screwing them into the
unit’s chassis through the holes in the bottom flanges.
Surface mounting with toggle bolts or wall anchors:
1.
Orient the support bracket on the wall with the small
flanges on top and the large flanges on the bottom.
Suggested mounting height is 48 inches from the floor
to the bottom of the mounting bracket.
2.
Mark the locations (C) for the four wall anchors or
toggle bolts (not included) and the area in the center of
the bracket where the cable(s) will come through the
wall using the support bracket as a template (see Figure
3).
3.
Drill the necessary holes for the toggle bolts or wall
anchors and cut or drill a hole in the center area for the
Smart Controller’s cables.
4.
Attach the mounting bracket to the wall using toggle
bolts or wall anchors (not included).
5.
Bring the cable(s) out through the support bracket
center cutout.
6.
Remove and discard the cable termination cover from
the back of the unit.
7.
Remove the two #8 × ½-inch mounting bracket screws
from the bottom of the rear panel and set aside (see Figure 4).
8.
Complete the necessary cable terminations per the instructions in the Wiring section below.
9.
With the proper orientation for the unit’s configuration, angle the unit to hook it onto the top flange brackets (D-D or E-E,
see Figure 4), then rotate and slide it downward until it rests on the mounting bracket.
10.
Secure the unit to the support bracket using the two #8 × ½-inch screws previously removed by screwing them up into the
unit’s chassis through the holes in the bottom flanges.
Figure 3. Smart Controller Wall-Mount Bracket
Figure 4. HUBBCOM™ Smart Controller—Rear View
