GAI-Tronics 12565-001 Operational, Installation, And Maintenance Manual Download Page 3

Page: 3 / 3

Pub. 42003-079C

ODEL

12565-001 P

RINTED

IRCUIT

OARD

SSEMBLY

EPLACEMENT

Page:

3 of 3

f:\standard ioms - current release\kits (42003)\42003-079c.doc

2/97

3. Place the board on the receiver with the antenna pointing up, away from the varistor.

4. Screw the board to the receiver with the green wire under the left screw where indicated.

5. Attach the red wire to the standoff in the center of the board.

6. Bend the antenna so that it is flat against the side of the receiver. Then bend the small end around the

corner so it is tight against the front of the receiver.

7. Place the receiver assembly in the handset.

8. Tighten the receiver cap.

Sold by:

http://www.TWAcomm.com

Toll Free: (877) 892-2666

Summary of Contents for 12565-001

Page 1: ...x Amplifiers Installation of this kit will upgrade your Model 701 10x Amplifier to a Model 701 20x Amplifier In the future you may replace the handset receiver the handset printed circuit board Model...

Page 2: ...he transformer from the printed circuit board 5 Remove the 2 screws which secure the top of the printed circuit board 6 Locate the plastic standoffs securing the board to the chassis Disconnect the bo...

Page 3: ...Screw the board to the receiver with the green wire under the left screw where indicated 5 Attach the red wire to the standoff in the center of the board 6 Bend the antenna so that it is flat against...