Pub. 42004-708L2B
Model 10962-001 and 10962-002 AMI Redundant Controller Modules
Page: 16 of 17
f:\standard ioms - current release\42004 instr. manuals\42004-708l2b.doc
06/10
The following functions may be changed using the web-page.
Function Meaning
Alarm Button
Mode
These radio buttons select the mode assigned to Input 2.
Selecting Silence mode will cause the AMI to stop playing its current message or
page when the button is pressed.
Reset mode will cause the AMI to clear all of its alarms and pages when the button
is pressed.
AMI
Communication
This button is used to select the communication interface between the ARC Board
and the AMI (RS-232 or RS-485). RS-485 is the default communication interface.
After changing this value, the ARC board MUST be reset. The web page must be
refreshed following the board reset.
Audio Dropout
Time
Assuming no audio is detected at the VOX 1 input, this setting value determines the
length of time (in seconds) before the ARC reports a “No Audio” condition and
switches control to the back-up AMI. The range is 5–10 seconds in 1-second
increments. The default value is 5 seconds. This parameter may need to be altered
if there are pause (silence) times in the AMI message greater than 5 seconds.
Audio Detect
Threshold
This setting specifies the threshold level at which the audio is detected by the ARC
board. Selecting the Disable option from the drop-down list will disable audio
detection. Valid values for audio detection are 1 through 10, ranging from 100 mV
to 1 V, in steps of 100 mV. The default value of this parameter is 3 (300 mV).
Set AMI Date or
Time
Allows the user to change the date and time on the corresponding AMI.
N
OTE
:
This is the only way to set the date/time on the AMI, and must be done separately
for each ARC board. The default web page values for date and time are set
according to the last date/time retrieved from the AMI. The data connection to the
AMI must be functioning properly to allow the date and time to be set.
ARC Controller
Configuration
Displays the network configuration data for the ARC board:
•
Current MAC address
•
Current IP address
•
Subnet mask
•
Gateway address
These values cannot be modified via the web page.
