36
ERROR CODES
GUIDE MESSAGE THAT APPEARS
HOW TO REMOVE THE MESSAGE
out of service (xx)
restart to fix…
Where (xx) identifi es an error code.Turn off and after 30
seconds turn the machine on again to restore normal
operation.If the problem persists, call the service centre and
give the code (xx) shown on the display.
close coffee bean lid
Close the coffee bean hopper cover to be able to make a
beverage.
fill container wth coffee
Put coffee beans into the bean hopper.
insert the brew group
Insert the brew group in its place.
insert grounds drawer
Insert the coffee grounds drawer.
empty grounds
Warning that does not block the machine. Proceed as for
the next alarm.
empty grounds drawer
Remove the grounds drawer and empty the grounds into an
appropriate container (See page 34, steps 1 and 2.).
Note: The grounds drawer must be emptied only when
the machine requires it and when the machine is turned
on. If you empty the drawer with the machine turned off
it will not record the emptying operation.
close door
In order for the machine to operate, the side door must be
closed.
fill the water tank.
The tank must be removed and refi lled with fresh drinking
water.
empty the drip tray
Open the side door and empty the drip tray located under
the Brew Group.
Warning: if this operation is performed when the
machine is on, it will record the coffee grounds drawer
emptying and will reset the relative counter; therefore,
it is necessary to empty the coffee grounds as well.
change the filter
The Aqua Prima fi lter must be replaced in the following
cases:
1. 60 litres of water have been dispensed;
2. 90 days have passed since its installation;
3. 20 days have passed and the machine has not been
used.
Note: this message only appears when “on” has been
selected in the water fi lter function (See page 21).
carafe missing
milk island missing
The steam knob has been turned to the
position and
either the Milk Island has not been installed or the carafe is
not positioned correctly. Install the Milk Island or position
the carafe correctly.
Otherwise, turn the knob until it is in the rest position ( ).