Gaggenau WT260110, User Manual

Page: 35 / 68

operation
en
35
operation
12 Basic operation
operation
12.1 Switching on the appli-
ance
Requirement:
The appliance has
been correctly installed and connec-
ted.
→
"Installation and connection",
Page 12
▶
Press .
The switch-on process takes a few
seconds.
Note:
The lighting for the drum goes
out automatically.
12.2 Setting a programme
1.
Turn the programme selector and
set the required programme.
→
"Programmes", Page 30
2.
If required, adjust the programme
settings.
→
"Adjusting the programme set-
tings", Page 35
12.3 Adjusting the pro-
gramme settings
Depending on the programme and
programme progress, you can adjust
or activate/deactivate the settings.
Requirement:
A programme is set.
→ "Setting a programme", Page 35
▶
Adjust the programme settings.
→
"Buttons", Page 26
Observe the information about op-
erating logic →
Page 22 .
Note:
The programme settings are
not saved permanently for the pro-
gramme.
Adjusting additional programme
settings
1.
Press to call up additional pro-
gramme settings.
2.
Select the programme settings.
3.
Press to call up the main
menu.
12.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡
A programme is set.
¡
The programme settings have
been adjusted.
▶
Press and hold
M1
or
M2
for
approx. 3 seconds.
Press
M1
or
M2
to call up the
saved programme.
Note:
To overwrite the saved pro-
gramme, repeat the steps above.
12.5 Loading laundry
Note:
To prevent creasing, note the
maximum load for the programmes.
→
"Programmes", Page 30
Requirements
¡
The laundry is prepared and sor-
ted.
→
"Laundry", Page 34
¡
The drum is empty.
1.
Open the door.
2.
Place the laundry in the drum.
3.
Close the door.
Ensure that there is no laundry
trapped in the door.
12.6 Starting the programme
Requirement:
A programme is set.
→ "Setting a programme", Page 35