en
Installation instructions
18
12.17 Sealing the joints
For flush installation, seal the joints with silicone.
Requirement:
You must carry out a function test before
sealing any joints.
1.
Seal all around the gap using suitable, heat-resistant
silicone, e.g. Novasil® S70 or Ottoseal® S70.
Unsuitable silicone adhesive causes permanent dis-
coloration to natural stone worktops.
2.
Use the smoothing agent recommended by the
manufacturer to smooth the joint.
3.
Observe the usage instructions for the silicone ad-
hesive.
4.
Leave the silicone adhesive to dry for at least 24
hours.
The drying time depends on the ambient temperat-
ure.
5.
Do not operate the appliance until the silicone has
dried completely.
12.18 Removing the appliance
ATTENTION!
Tools may damage the appliance frame.
▶
Do not prise out the appliance from above.
1.
Disconnect the appliance from the power supply.
2.
If the appliance is flush-mounted with the surround-
ing surfaces, remove the silicone seal.
3.
Push out the appliance from below.
