10
en-us
Installation Procedure
5.
Connect all of the control knobs with the enclosed
shorter cables. The plugs must snap into the sockets
(E)
.
Note:
The two cable connectors on the control knob
are identical.
6.
Connect the longer cable to the control cable for
connection to the appliance. The plug must snap into
the socket
(F)
.
Note:
The appliance can be connected to any control
knob.
7.
After installing, check that all plug connections fit
correctly.
8.
After installing all the cables, secure them to the
retaining plate by bending the tab down
(E)
.
Installing the heat shield
9
CAUTION
Sharp edges. Use protective gloves when installing
the plate.
For safety reasons, the heat shield must be properly
installed. This prevents components from overheating as
a result of the recirculation of hot air from the cooktop.
The heat shield is the same width as the cooktop. For
shipping, it is screwed to the burner box.
After unpacking the cooktop, unscrew the heat shield.
The heat shield will be able to rotate freely, as shown in
the illustration.
$
%
&
'
(
)
