13
Operating the appliance
en-us
Individual parts of the standard-output burner and
high-output burner
Operating the appliance
Operating the appliance
Notes
▯
Only use the accessories specified. Do not line the
stainless steel recess (e.g. with aluminum foil).
▯
The burner and ignition plug must be clean and dry.
▯
Only light the burners if the pan supports and all
burner parts are correctly fitted.
▯
When one burner is ignited, an ignition spark will also
be generated at all the other burners.
▯
Do not touch the ignition plug while the gas appliance
is being lit.
▯
It is important to keep the appliance clean. If the
ignition plugs are dirty, this may cause ignition
problems. Clean the ignition plugs regularly with a
small, non-metallic brush. Take care to prevent the
ignition plugs from suffering any heavy knocks.
▯
When you switch from setting 3 to setting 4 or higher,
the burner will briefly switch to its maximum output.
This is to optimize ignition between the burner rings.
▯
Do not cover the ventilation openings on the rear of
the gas cooktop.
▯
When the gas cooktop is switched on, the electronics
open up the gas supply, which produces a short
sound. This is normal.
▯
In the event of a power failure, the appliance will not
work. The gas supply is shut off.
(
Burner cap
0
Burner ring
8
Burner head
@
Ignition plug
H
Thermocouple
#
+
