18
8.3 Installation
–
Produce the recess for one or several Vario
appliances in the worktop.
Proceed as shown
in the installation sketch and the dimension table.
The dimension table contains the space
requirement for the connecting strip between the
appliances.
Important:
the angle between the cut surface
and the worktop must amount to 90°. (Fig. 20)
–
Mark the centre of the recess exactly.
Secure
the securing rails on both sides in the recess.
Make sure that the lugs of the securing rails lie on
the worktop and that the centre marking on the
securing rails is precisely flush with the centre
marking on the worktop (Fig. 21).
–
Lower the appliance into the worktop.
Make
sure that the engaging lugs on the appliance lie
exactly on the clamping springs. Press the
appliance firmly into the worktop. The engaging
lugs on the appliance “snap” into the clamping
springs (Fig. 22).
Note:
When installing the appliance in granite or
marble worktops, have the holes produced by a
specialist or stick on the securing rails with a
temperature-resistant 2-component adhesive (metal
on stone).
18
5080004010 en 7.00 SK
490
510
288
1,7 m
8,5
190
min. 3
0
min. 5
0
490
651
365
943
132
5
268
min.
Secure the cover on the appliance
before
assembly
. (See assembly instructions VD 201-010.)
Note:
Several appliances can also be installed in
individual recesses, as long as a minimum
clearance of 40 mm is kept to between the
appliances.
Fig. 20
Fig. 21
Fig. 22
