Gaggenau RY 491, Installation Instructions Manual

Page: 20 / 100

20
10. Installing and aligning the appliance

Align the appliance with the furniture fronts.
Place marking-out level over the installation aid parts on
the door.
The installation aid parts on the door have been designed for
the following total thickness of furniture doors:
–
3
/
4
" (19 mm)
– 1
1
/
2
" (38 mm)
Always take account of the possible differing thickness of the
furniture fronts which are to be fitted subsequently.
The height-adjustable feet at the front and rear can all be
adjusted from the front.
Front: with open-ended wrench
1
/
2
" (SW13)
Rear: with
5
/
16
" (8 mm) hex nut driver via flexible shaft.
A mark is attached to the appliance base and is used as
a standard gage for height adjustment. When adjusting the
height, align this mark at a height of 1
1
/
2
" (32 mm) above
the floor.

Unscrew the height-adjustable feet until the mark on
the base has reached the indicated guide dimension
(1
1
/
4
" / 32 mm).

Align the furniture fronts with the spirit level.
m
CAUTION
m
Never use a cordless screwdriver!
Risk of damage to the appliance.
NOTE
– Do not twist or jam the appliance inside the cavity!
When unscrewing the height-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
– The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
– Do not bend the appliance against the anti-tip-
angles.
NOTE
It is very important to comply with this dimension
for the subsequent alignment of the furniture fronts.