Gaggenau DF 460-161, Operating Instructions Manual

Page: 17 / 24

17
“check water supply”
4
display lights up.
Tap turned off.
Water supply interrupted.
Supply hose kinked.
Filter in the water supply blocked.
Switch off the appliance and pull out the
mains plug.
Turn off the tap.
Clean filter in the supply hose.
Reconnect power supply.
Turn on the tap.
Switch on the appliance.
Water is left in the appliance at the end of
the programme.
(E24) Waste water hose is blocked or kinked.
(E25) Waste water pump blocked, cover on
the waste water pump is not locked in
position (see Maintenance and Care).
Filters blocked.
The programme has not yet ended. Wait until
programme ends (digital display indicates
0:00) or implement the ”Reset” function.
Refill indicator for salt
5
and/or rinse-aid
6
is not lit.
Refill indicator/s switched off.
Adequate salt/rinse-aid available.
Refill indicator for special salt
5
is lit.
No salt.
Refill with salt.
Sensor does not detect salt tablets.
Use different special salt.
... during the wash cycle
Unusual foam formation
Handwash liquid in the rinse aid dispenser.
Spilled rinse-aid causes excessive frothing,
therefore please remove with a cloth.
Appliance stops during the wash cycle.
Power supply interrupted.
Water supply interrupted.
Knocking/rattling noise during rinsing
Spray arm is striking utensils.
Utensils not arranged correctly.
Filling valves making striking noises
Caused by the installation of the water line and
has no effect on the function of the machine.
Remedial action is not possible.
... on the utensils
Food residue on the utensils.
Utensils placed too closely together, utensils
basket overfilled.
Too little detergent.
Rinse programme too weak.
Spray arm rotation obstructed.
Spray arm nozzles blocked.
Filters blocked.
Filters incorrectly inserted.
Waste water pump blocked.
Top basket on right and left not set to same
height.
Tea or lipstick residue is not completely
removed.
Detergent has inadequate bleaching effect.
Too low rinsing temperature.
Too little/unsuitable detergent
White stains on the utensils/glasses remain
milky.
If phosphate-free detergents are used with hard tap
water, white deposits may be deposited more easily on
utensils and the container walls.
Too little/unsuitable detergent.
Too weak programme selected.
No/too little rinse-aid.
No/too little salt.
Water softening system set to the wrong value.
Salt dispenser lock not fastened.
Contact the detergent manufacturer, in particular if:
the utensils are very wet at the end of the
programme.
limescale forms.
Dull, discoloured glasses, film cannot be
washed off.
Unsuitable detergent.
Glasses not dishwasher-proof.
Streaks on glasses and cutlery, glasses have
metallic appearance.
Too much rinse-aid.
Plastic parts discoloured.
Too little/unsuitable detergent.
Too weak programme selected.
Rust spots on the cutlery.
Cutlery not rust-resistant.
Salt content in the rinsing water too high, as salt
dispenser lock not fastened firmly or salt was
spilled while being refilled.
Utensils not dry.
Appliance door opened too early and utensils
taken out too early.
Programme selected without drying.
Too little rinse-aid.