Gaggenau DF 280, Operating Instructions Manual, Page: 39 / 104

39
Troubleshooting
en-us
Error code
“
:
ƒ…
is lit. Waste-water hose kinked or blocked. Install hose without kinks, remove any
residue.
Siphon connection still sealed. Check connection to siphon and open if
required.
Cover on the drain pump loose. Lock cover correctly.
Error code
“
:
Ġ
is lit. Drain pump blocked or cover on the
drain pump is not locked in position. Clean pump and lock cover correctly.
Error code
“
:
ƒˆ
is lit. Mains voltage too low. Not an appliance fault, have the mains
voltage and electrical installation checked.
A different error code is
indicated on the digital display.
(
“
:
‹‚
to
“
:
„‹
)
A technical fault has probably
occurred. Switch off appliances with the ON/OFF
switch
(
. After a short time restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the
error code.
Refill indicator for salt
P
and/
or rinse-aid
H
is lit.
No rinse aid. Refill rinse aid.
No salt. Refill with special salt.
Sensor does not detect salt tablets. Use different special salt.
Refill indicator for salt
P
and/
or rinse-aid
H
is not lit.
Refill indicator switched off. Activation/deactivation
~
"
,
Rinse Aid",
~
"Water softening system / special salt"
There is still enough special salt/
rinse aid available. Check refill indicator, levels.
Water is left in the appliance at
the end of the wash cycle. Filter system or area under the filters
1Z
is blocked.
Clean filters and area underneath.
Wash cycle has not ended yet. Wait until wash cycle ends or reset.
Dishes not dry. No or too little rinse aid in the
dispenser. Refill rinse aid.
Wash cycle selected without drying. Select wash cycle with drying.
Water collecting in depressions on
the dishes and silverware. Arrange dishes in a sloping position,
arrange affected dishes as sloping as
possible.
The combined detergent used has a
poor drying performance Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
extraDry to increase drying not
activated. Activate extraDry.
Dishes were removed too early or
drying process had not ended yet. Wait until wash cycle ends or wait until 30
min after wash cycle ends before removing
dishes.
The eco rinse aid used has a limited
drying performance. Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic dishes not dry. Special properties of plastic. Plastic has a lower heat storage capacity
and therefore dries less well.
Fault Cause Remedial action