Gaggenau DF 240-161, Operating Instructions Manual

Page: 19 / 23

19
Warning
If the appliance is not in a cavity and a side panel is
accessible, the door hinge area must be covered at the
side for reasons of safety (risk of injury). The covers
are available as optional accessories from customer
service or specialist outlets.
Delivery
Your dishwasher has been checked thoroughly in the
factory to ensure that it is in working order. This may
cause small water stains. These will disappear after the
first wash cycle.
Installation
The required installation dimensions can be found in
the installation instructions. Level the appliance with the
aid of the height-adjustable feet. Ensure that the
appliance is situated securely on the floor.
A built-under or integrated appliance which is
installed subsequently as a free-standing appliance
must be secured to prevent it from overturning, e.g.
by screwing it to the wall or by installing it under a
continuous worktop which is screwed to adjacent
cupboards.
The appliance can easily be installed in a fitted
kitchen between wooden and plastic walls. If the
plug is not freely accessible following installation,
an allpole disconnector with a contact opening of at
least 3 mm must be fitted on the installation side to
satisfy the relevant safety regulations.
Waste-water connection
The required work sequence can be found in the
installation instructions. If required, fit a siphon with
an drainage connection.
Connect the waste-water hose to the drainage
connection of the siphon with the enclosed parts.
Ensure that the drainage hose is not kinked, crushed
or twisted and that there is no cover plate in the
drainage to prevent the waste water from flowing
out!
Fresh-water connection
Connect the fresh-water connection to the tap
according to the installation instructions with the
enclosed parts.
Ensure that the fresh-water connection is not kinked,
crushed or twisted.
When replacing the appliance, always use a new
water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum 1 MPa (10 bar).
At a higher water pressure: connect pressure-reducing
valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
connect to COLD WATER ONLY.
Electrical connection
Connect the appliance to an alternating current only,
ranging from 220 V to 240 V and 50 Hz or 60 Hz via
a correctly installed socket with protective earth
conductor. See rating plate for required fusing
33
.
The socket must be near the appliance and freely
accessible following installation.
The connection may be modified by technicians only.
A power cord extension may be purchased from
customer service only.
Use only a residual-current-operated circuit-breaker
which features the symbol. Only this extension
guarantees compliance with the currently valid
regulations.
Removing the appliance
Also observe the sequence of worksteps here.
Disconnect the appliance from the power supply.
Turn off the water supply.
Disconnect the waste water and fresh water
connections.
Loosen the fastening screws under the worktop.
If fitted, remove the base panel.
Pull out the appliance, carefully pulling the hose
behind.