11
auto 3in1
The use of so-called combined detergent products may
make the use of rinse aid and/or salt unnecessary.
There are currently several types of combined
detergent products available.
2in1: They contain detergent and rinse aid or salt
function.
3in1: They contain detergent, rinse aid and salt
function.
4in1: They contain a detergent, rinse-aid, salt
function and an additional glass protection
component.
In addition, other combined products with a comparable
effect are offered according to the manufacturer.
>>> Always check the type of detergent or
combined product which you are using!
Always follow the operating instructions or the
information on the packaging.
The rinse programme is automatically adjusted in order
to obtain the best possible rinsing and drying result.
Observe the following important information if using
combined cleaning products:
Regeneration salt is not required up to a water
hardness of 21
_
dH (37
_
fH, 26
_
Clarke, 3.7 mmol/l)
only. No other settings on the appliance are required.
Salt is still required if the water hardness is above
21
_
dH (37
_
fH, 26
_
Clarke, 3.7 mmol/l). Fill the salt
dispenser with salt
24
and select setting 6 on the
water softening system.
If in doubt, please contact the detergent manufacturer,
especially if:
the utensils are very wet at the end of the
programme.
limescale forms.
Note
Optimum rinsing and drying results can be obtained by
using standard detergents in conjunction with separate
application of salt and rinse aid.
Observance of the operating instructions or information
on the packaging of the combined detergents
determines their effectiveness.
Note
Even if the rinse aid and/or salt refill indicator is lit, the
rinse programme runs correctly when 3in1 products are
used.
If the rinse aid refill indicator
6
or salt refill
5
indicator is defective and you would like to switch it off,
proceed as follows:
Switching the rinse aid refill indicator
off and on
Hold down the programme button
3
and press the
main switch
1
until the digital display lights up,
then release the buttons.
9
is indicated on the
digital display
.
Each time the button
3
is pressed, the set value
increases by one; when the value
is reached, the
display jumps back to
. To switch off, select the
position.
Switch off the main switch
1
; the setting is saved.
Switching the salt refill indicator /
water softening system off and on
Hold down the programme button
B
and switch on
the main switch
1
, then release the buttons.
The illuminated button
B
and the factory-set value
on the digital display flash.
To change the setting: press the programme button
B
.
Each time the button is pressed, the set value
increases by one; when the value
is reached, the
display jumps back to
(the salt refill indicator /
water softening system has been switched off).
Switch off the main switch
1
. The set value is
stored within the device.
Approx. 4 litres of water are required to regenerate the
water softening system. As a result, the water
consumption per rinse cycle increases by 0 to
maximum 4 litres depending on the water hardness
setting.
Note
If you use the detergent and rinse aid separately or
switch from combined detergents to standard cleaning
products, ensure that the rinse aid refill indicator has
been switched on and the water softening system has
been set to the correct water hardness.
