Gaggenau CV 282, Instruction Manual

Page: 54 / 64

54
en
Cleaning
3 Insert two of the activated charcoal filters or
acoustics filters into the left and right of the
appliance and slide them forwards.
4 Insert the other activated charcoal filters or
acoustics filters into the left and right of the
appliance.
5 Insert the metal grease filter.
6 Put the ventilation grille in place.
Resetting the saturation displays
If you have replaced the activated charcoal filters, you
should reset the saturation indicator so that the
” ’•‘¯®“
display goes out.
After the appliance has been switched off,
” ’•‘¯®“
lights up.
Press and hold the
}
symbol until an audible signal
sounds.
The activated charcoal filter saturation indicator has
now been reset.
Removing metal grease filter
The metal grease filters filter the grease out of kitchen
steam. To keep it in good working order, the metal
grease filter must be cleaned regularly.
Also clean the inside of the hob extractor system
regularly. You can use a special degreaser to remove
stubborn dirt (article no. 00311297).
1 Remove the ventilation grille. Remove the metal
grease filter.
Notes
–
Grease may accumulate in the bottom of the
container. Hold the metal grease filter level to
prevent grease from dripping out.
–
Make sure that the metal grease filter does not
fall and damage the hob.
2 Clean the metal grease filters in the dishwasher or
with hot soapy water.
~
"Cleaning the metal
grease filter" on page 54
3 If required, after removing the metal grease filter,
remove the activated charcoal filter and clean the
appliance from the inside.
4 After cleaning, reinsert the dried metal grease filter.
5 Put the ventilation grille in place.
Cleaning the metal grease filter
Notes
– Do not use aggressive, acidic or alkaline cleaning
products.
– The metal grease filter can be cleaned in the
dishwasher or by hand.
By hand:
Note: You can use a special degreaser to remove
stubborn dirt (article no. 00311297). This can be
ordered through our online shop.
▯
Remove the metal grease filter.
▯
Soak the metal grease filter in hot soapy water.
▯
Clean the metal grease filter with a brush and then
rinse it thoroughly.
▯
Leave the metal grease filter to drain.
1I 2