Gaggenau BS 470 612, Use And Care Manual

Page: 17 / 68

17
Before using the appliance for the first time
en-us
K
Before using the appliance for the
first time
Before using the appliance for the first time
In this chapter, you can find out what you must do
before using your oven to prepare food for the first time.
First read the section entitled
~
"IMPORTANT SAFETY
INSTRUCTIONS" on page 4
.
The appliance must be completely installed and
connected.
After connecting the appliance to the power supply, the
"Initial settings "menu will be displayed. Now you can now
configure your new appliance for initial set-up.
Notes
▯
The "Initial settings" menu will appear only after the
appliance has been connected to a power supply and
switched on for the first time, or if the appliance has
not been connected to a power supply for a number of
days.
Once the appliance has been connected to a power
supply, the GAGGENAU logo will appear first for
approximately 30 seconds. The "Initial settings" menu
will then appear automatically.
▯
You can change the settings at any time in the basic
settings.
~
"Basic settings" on page 37
Setting the language
The default language appears in the display.
1.
Select the desired display language with the rotary
selector.
2.
Confirm with
™
.
Setting the time format
the two possible formats 24h and AM/PM appear in the
display. The default format is 24h.
1.
Set the required format with the rotary selector.
2.
Confirm with
™
.
Setting the time
The time appears in the display.
1.
Set the required time with the rotary selector.
2.
Confirm with
™
.
Setting the date format
The three possible formats D.M.Y, D/M/Y and M/D/Y
appear in the display. The D.M.Y is the default.
1.
Set the required format with the rotary selector.
2.
Confirm with
™
.
Setting the date
The default date appears in the display. The day setting is
already active.
1.
Set the required day with the rotary selector.
2.
Switch to the month setting with the
C
symbol.
3.
Set the month with the rotary selector.
4.
Switch to the year setting with the
C
symbol.
5.
Set the year with the rotary selector.
6.
Confirm with
™
.
Setting the temperature unit
The two possible units °C and °F will appear on the
display. The default unit is °C.
1.
Use the rotary selector to select the unit you require.
2.
Press
™
to confirm.
Setting the water filter
"Water filter” appears in the display. The default is
"Available".
It is recommended to install a suitable descaling system
if the water hardness exceeds 7°dH (carbonate hardness
5°dH).
1.
Use the rotary selector to select "Available" (with
water filter) or "Not available" (without water filter).
2.
Confirm with
™
.
3.
If water filter "Available" has been selected:
"Water filter capacity” is shown in the display.
4.
Turn the rotary selector to select the capacity of the
filter cartridge (between 100 - 9000 liters). Refer to
the instructions included with the filter cartridge.
5.
Confirm with
™
.