Gaggenau AW 480, Operating Instructions Manual

Page: 11 / 16

11
Cleaning and care
Cleaning the grease filters
The grease filter saturation display F flashes after
an operating time of 30 hours to you indicate to you
that you should clean the grease filter. The grease
filters can of course be cleaned at any time, even if
the grease filter saturation display has not started
to flash.
1 The stainless steel grease filters can be
removed easily for cleaning:
2 Disconnect the power supply (switch off the
fuse).
Grip the grease filter handle and push the slide
towards the rear. Then pull the grease filter
downwards out of the holder; repeat the
operation for the other grease filters.
3 You can clean the stainless steel grease filters
in a dishwasher at a maximum temperature of
65°C, where it should be supported vertically
to allow food or rinsing residues to drain off.
If possible, the inner parts of the housing should be
wiped out in hot rinsing water when replacing the
filters.
Caution:
when cleaning the inside of the housing, beware of
protruding parts..
After having cleaned them, re-insert the grease
filters in the wall extractor in reverse order.
Important :
the handles of both grease filters must be visible
after assembly.
Press the F key to set the elapsed hours counter to
zero. Flashing of the indicating lamp goes off.