Gaggenau AL200180, User Manual And Installation Instructions

Page: 18 / 24

en
Installation instructions
18
¡
Do not use any flat ducts with sharp bends.
Round pipes
Use round pipes with an inner diameter of 150 mm (re-
commended) or at least 120 mm.
15.7 General information
Follow these general instructions during the installation.
¡
For the installation, observe the currently valid build-
ing regulations and the regulations of the local elec-
tricity and gas suppliers.
¡
When discharging the exhaust air, the official and
legal regulations, such as the regional building
code., must be observed.
¡
The width of the extractor hood must correspond at
least with the width of the hob.
¡
To optimally detect the cooking vapours, install the
appliance behind the hob.
¡
In order to freely access the fan box for servicing,
select an easy-to-reach installation site.
¡
The surfaces of the appliance are sensitive. Avoid
damaging them during installation.
15.8 Installation
Checking the units
▶
Check whether the fitted unit is level and has suffi-
cient load-bearing capacity.
The max. weight of the appliance is 40 kg.
Preparing the units
Notes
¡
To install the hob and the appliance seamlessly, you
require special accessories, which are not included
in the scope of delivery. Observe the enclosed in-
stallation instructions for special accessories.
¡
To surface-mount the hob and the appliance, you re-
quire special accessories which are not included in
the scope of delivery. Observe the enclosed installa-
tion instructions for special accessories.
Requirement:
The unit is suitable for the installation.
1.
Make a cut-out in the worktop, depending on the in-
stallation position.
The angle between the cut surface and the worktop
must be 90°.
2.
Ensure that the worktop has sufficient load-bearing
capacity and stability.
Use a heat- and humidity-resistant reinforcing mater-
ial for any substructure.
3.
Ensure that the fitted unit is still stable after the cut-
outs have been made.
4.
Remove any shavings.
5. Depending on the installation position, remove the
back panel of the fitted unit.
Preparing the appliance
WARNING ‒ Risk of injury!
The appliance is heavy.
▶
To move the appliance, two people are required.
▶
Use only suitable tools and equipment.
Note:
To surface-mount the hob and the appliance, you
require special accessories which are not included in
the scope of delivery. Observe the enclosed installation
instructions for special accessories.
1.
Place the appliance on a soft surface and remove
the transport lock.