3
WARNING
Do not remove and add hoses without
using flats on 750128 tube assembly.
Severe personal injury could result.
WARNING
Hydraulic power units that deliver high
pressure for the "PULL" and "RETURN"
and are not equipped with relief valves
are specifically not recommended and
may be dangerous.
CAUTION
Keep Nose Assemblies clean and free
of
chips and debris.
WARNING
Be sure there is adequate clearance for
tool and operator's hands before
proceeding. Keep fingers clear of any
moving parts. Keep fingers clear from
fasteners and installed materials.
Severe
personal injury may result.
WARNING
When operating installation equipment
always wear approved eye protection. Do
not look in front of nose assembly or rear
of tool when installing fastener.
WARNING
Installation of fasteners may exceed
acceptable noise levels. Use approved
hearing protection.
WARNING
Do not pull fastener unless it is placed
in
an assembly, pin will eject forcibly
when
pintail breaks off. Severe
personal injury
may result.
CAUTION
Insure that nose assembly and tip
are
properly matched for the
fastener being
installed.
CAUTION:
GAGE BILT TOOLS ARE APPROVED TO INSTALL HUCK®, AVDEL®, CHERRY®, POP®
AND OTHER FASTENERS WHEN USED BY PERSONS WITH SPECIFIC TRAINING OF BLIND
RIVET AND LOCKBOLT INSTALLATION EQUIPMENT.
WARNING
Always disconnect tool from powerunit
before performing any maintenance
to
any tool or nose assembly.
Insure
that all
connections are proper and
there are no
visible leaks from tool
or hoses before
connecting to
power
.
NOTE:
PLEASE READ THIS MANUAL BEFORE SERVICING OR USING THIS
TOOL. COMPLETE WITH WARNINGS AND CAUTIONS TO PREVENT
SEVERE PERSONAL INJURY OR DAMAGE THE TOOL.
