Gage Bilt GB731OSSH, Original Instructions Manual

Page: 8 / 24

8 REV 6/22 GB731OSSH INSTALLATION TOOL
HOW TO SET - UP THE GB731OS/206SH
WARNING:
Only qualified and trained operators shall install, adjust or use the assembly power tool for non - threaded
mechanical fasteners.
WARNING:
Operator MUST read and understand all warnings and cautions.
WARNING:
It is required that eye protection, hearing protection and safety boots be worn at all times while handling this
equipment.
WARNING:
The users or the user ’ s employer must assess specific risks that could be present as a result after each use
based on their application.
● Ensure there is adequate clearance for tool and operator's hands before proceeding. Keep fingers clear of
any moving parts. Keep fingers clear from fasteners and installed materials. Severe personal injury may result.
● Verify the air lines and/or hydraulic hoses are not a trip hazard.
● Ensure that there are no electrical cables, gas pipes, etc., which can cause a hazard if damaged by the tool
WARNING :
Do not actuate fastener in the air. Personal injury from fastener ejecting may occur.
WARNING:
Air is exhausted from the bottom of the tool. Direct bottom of the tool (exhausted air) away from operator, other
persons working in the vicinity, foreign matter and liquid.
WARNING:
Do not carry from hoses or use as a hammer.
WARNING:
Do not use in explosive atmosphere.
WARNING:
Ensure air hose is securely connected to avoid possible hose whipping.
WARNING:
Always disconnect air supply when tool is not in use to prevent accidental start - up.
WARNING:
Ensure there is adequate clearance for tool and operator hands.
CAUTION:
Do not use beyond the design intent.
The tool is shipped with a red plastic plug in the air inlet connector. The connector has a 1/4 - 18 female pipe thread to accept user air
hose fitting. The tool comes with oil and is ready to use.
1. Remove red plastic shipping plug from Swivel (A - 249) (air inlet) and screw in your quick disconnect (air) fitting.
2. Connect tool to air hose with 90 psi. (6.2 bar) using clean, dry air. 3/8” (9.52 mm) minimum diameter air line is recommended.
Cycle tool five times by depressing and releasing actuator lever assembly (704343).
3. Disconnect air hose from tool.
4. Select proper nose assembly. (See nose assembly chart on pg. 20 for more information).
5. Attach nose assembly.
5a. Unscrew and remove socket head cap screw (400057)
and spacer (730906) from head cylinder assembly (731912).
5b. Thread nose assembly onto tool.
5c. Remove nut (71114) attached to drawbar on nose assembly. Insert drawbar into nose assembly
and thru piston on tool. (Note: Nut (352211) comes with tool to replace Nut (71114).
5d. Using Allen wrenches supplied with tool, insert into draw bar and into nut (352211)
and tighten nose assembly and nut (352211) to tool.
(See proper data sheet for further instructions).
5e. Insert socket head cap screw (400057) into spacer (730906)
and reattach to head cylinder assembly (731912).
6. Connect air supply.
USER QUICK DISCONNECT FITTING
AIR HOSE
RED SHIPPING PLUG
AIR INLET
HEAD CYLINDER
NOSE ASSEMBLY
FASTENER
WORK
ACTUATOR
Images may not reflect actual tool
Thread nose
assembly to
tool
Insert draw bar
into anvil & thru
piston on tool.
Insert Allan
wrenches into
drawbar and into
Nut (352122) &
tighten to tool.
S.H.C.S. (400057)
SPACER (730906)