15
11/21 REV 3/23
GB703SRVTPTS INSTALLAION TOOL
ACTUATOR ASSEMBLY
-
AIR
WARNING
:
Disconnect tool from its power source before actuator removal or installation. Severe personal injury may occur if
power source is not disconnected.
CAUTION:
Actuator assembly
-
air (704130) can break if not careful.
CAUTION:
Do not over tighten actuator assembly
-
air (704130). Snug tighten only.
OVERHAUL
REMOVING ACTUATOR ASSEMBLY
-
AIR (704130)
1.
Remove air supply from tool.
2.
Remove nose assembly and pintail evacuation tube from tool.
3.
Using a
5/8”
wrench or an adjustable wrench, loosen and remove the actuator
assembly
-
air (704130) from the adapter (704325) as shown above.
INSTALLING ACTUATOR ASSEMBLY
-
AIR (704130)
1.
Apply Teflon® tape onto threads of actuator assembly
-
air (704130) one to two wraps.
2.
After replacing o
’
ring on the actuator assembly
-
air (704130), insert the actuator
assembly
-
air (704130)into the adapter (704325) and hand thread until the actuator
assembly
-
air (704130) stops.
3.
Using a
5/8”
wrench or an adjustable wrench, lightly tighten the actuator
assembly
-
air (704130) to the adapter (704325) as shown above. Do not over
tighten as this may damage or break the actuator assembly
-
air (704130).
Image may not
reflect actual tool