3
REV. 1/15
WARNING
Do not pull fastener unless it is placed
in an
assembly with collar, pin will eject forcibly
when
pintail breaks off. Severe
personal injury may result.
WARNING
When operating, repairing or overhauling tool, wear
approved eye protection. Do not look in front of
nose assembly or rear of tool when installing
fastener.
WARNING
Hydraulic power units that deliver high-pressure for
the “PULL” and “RETURN”, and are not equipped
with relief valves are specifically not recommended
and may be dangerous.
CAUTION
Keep Nose Assemblies clean and free
of chips and
debris.
WARNING
Be sure there is adequate clearance for
tool and
operator's hands before
proceeding. Keep fingers
clear of any moving parts. Keep fingers clear from
fasteners and installed materials.
Severe personal
injury may result.
WARNING
It is required to use hearing protection. A test was
carried out in a simulated work environment where
the background level was 73.2 dB (A). In this
condition the max level was 81.5 dB (A). Therefore,
it is required where prolonged use, hearing
protection be used.
WARNING
Do not use beyond the design intent.
WARNING
Tool must be maintained in a safe working
condition at all times and examined on a daily basis
for damage or wear. Any repair should be done by
qualified personnel trained on Gage Bilt
procedures.
WARNING
Where prolonged use is foreseen, it is
recommended a tool balancer be used. Check
suspension device to ensure that it is secure.
WARNING
Do not use tool in explosive atmosphere.
WARNING
Tool is not to be used as a hammer.
WARNING
Risk of crushing exists if nose assembly is not
attached.
WARNING
It is recommended tool be operated 50 out of every
60 minutes, where prolonged use is expected.
WARNING
Shock:
It is recommended operator wear a suitable gloves
during operation where prolonged use is expected.
CAUTION
Hydraulic pressure not to exceed 7,400 PSI (510.2
bar) pull, 3,200 PSI (220.6 bar) reload.
SAFETY WARNINGS
PLEASE READ THIS MANUAL BEFORE
SERVICING OR USING THIS TOOL.
WARNINGS:
MUST BE UNDERSTOOD TO AVOID
SEVERE PERSONAL INJURY
CAUTIONS:
SHOW CONDITIONS THAT WILL
DAMAGE EQUIPMENT OR STRUCTURE
WARNING
Always disconnect tool from power source before
performing any maintenance
to any tool or nose
assembly.
CAUTION
Ensure that nose assembly and tip
are properly
matched for the
fastener being installed.
WARNING
Ensure
that all connections are properly secured
before connecting to power.
