P a g e
|
18
•
Contact local utility…
Contact your local power utility grid company and all authorities having
jurisdiction (AHJ) to get necessary approvals before interconnection.
•
Set-up monitoring…
The monitoring system of the power electronics must be configured in order
to commission the solar system.
Recommended Tools
The following tools (Figure 14) are needed to properly install a DecoTech™ Solar System (this list is
representative only; additional tools may be required depending on the installation):
•
Standard selection of roofer’s tools
•
Cordless drill
•
5/16" (8 mm) Hex driver bit (for the solar foot GND screw)
•
#2 Phillips driver bit (for TE grounding clip & starter bar cover)
•
#3 Phillips driver bit (for deck screws)
•
1/2" (13 mm) socket (for MLPE screw & S-8 split-bolt)
•
7/16" (11 mm) wrench
•
Chalk line
•
Drill bit for array exit wires
•
Torque wrench
•
Wiring, conduit, enclosures, and disconnects from roof penetration down through the house
•
Wire cutters
•
Wire strippers
•
Solar crimping tool
Figure 14: Recommended tools