Initial Setup for Wireless IP Networking
Camera (NC1000-W10)
1.
Please reset the camera to factory default by pressing the button in the hole to the left of the
lens. Make sure the power is on, and then hold the button for 10 seconds.
2.
Once it has been reset, connect the camera to your computer using the cross-over (gray)
cable.
3.
Make sure your computer is set to obtain an IP address automatically.
Right click on “My Network Places” on your desktop and choose “Properties”.
Right click on “Local Area Connection” and choose “Properties”.
Gadspot, Inc.
Tel. 626-442-5588
10505 Valley Blvd Suite#638
Fax. 626-579-6666
El Monte, CA 91731
Email. [email protected]
