49
Restore Factory Default Settings
In some cases, system does not respond to any operation, this process gets the unit back to initial status, so that it
can be reconfigurable for up and running again.
To restore factory default, follow the steps below:
1.
Unplug the power jack to turn off the camera
2.
Insert a pin into the reset hole Sense a button and keep it pressed until instructed to release.
3.
Plug in the power jack to turn on the camera. The power LED will start flashing in a short while.
4.
Release the pin when the LED starts quick flashing. The device should be set back to factory default.
Summary of Contents for N600E
