Gadhouse MATHIS, User Manual

Page: 8 / 12

Turntable Function (LP)
1. Press the Power Switch to turn on the power.
2. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
3. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is
in place whenever the turntable is being moved or cleaned.
4. Open the tonearm clip from left to right.
5. Gently pull up the tonearm from its rest and move it over the record
where play is desired to begin. Use the Tonearm Lift Lever to raise the
Tonearm Lift and let the tonearm sit on it.
Note: The platter will auto start when the Tonearm leave the its rest
6. Set the Tonearm Lift Lever back to the down position, the tonearm will
descend slowly onto the record and begin playback.
7. When the record is finished playing, use the Tonearm Lift Lever to raise
the tonearm and then return it to the tonearm rest. To suspend the
playback, repeat the same steps.
2. Connection to the Amplifier
This turntable uses a moving magnetic cartridge. Set the PHONO & Line
Out Switch on PHONO Position. Connect the phono out cables to the
phono input on your amplifier of pre-amplifier (phono stage). Line inputs
such as CD, Tuner, Tape, or Video are not suitable for phono inputs.
Make sure the amplification of the selected input matches the type of
cartridge being used. The factory installed cartridge is 47k ohms/MM-input.
NOTE: If your amplifier does not have an input suitable for phono cartridges,
you will need to purchase a separate phono amplifier for moving magnetic
cartidges. This separate phono amplifier will then connect between your
turntable and your amplifier.
1.Slip the loop of the anti-skating
weight’s thread over the 3rd
groove of the stick to set correct
anti-skating force for the
factory-fitted cartridge. 2.Feed the thread through the loop
of the wire hanger.
OPERATION
OUTPUT
INPUT
1. Bluetooth Transmitter Operation
This turntable has a Bluetooth transmitter to wirelessly send audio to
Bluetooth speaker.
1. Power on your Bluetooth speaker and ensure it is in pairing mode.
2. Power on the turntable. BT will auto search when the turntable turns on
and the BT LED indicator light will flash.
3. When pairing, the light will flash twice per second and will become solid
when paired successfully.
4. To disconnect pairing, power off the turntable to turn off Bluetooth
pairing on your Bluetooth speaker.
5. This turntable will connect to the nearest Bluetooth speaker.
If after 2 minutes no Bluetooth speaker can be found to pair with,
the Bluetooth transmitter will become inactive and the LED will
turn off. If you need to connect again, power off the turntable and
the speaker then power on again.
Bluetooth Indicator
Flash
Solid
Off
Auto searching and pairing
Paired successfully
Inactive
Bluetooth Status
14
15