3
Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6550 Enhanced Electronic Governor
5-2020-A1
PIB1118
4
WIRING
A
D
C
B
E F
N P
Actuator
Battery
- +
Magnetic
Speed
Pickup
Fuse 15A M
ax
Ground to Case
(12V or 24V)
A
N
D
C
B
E
H
G
F
L
K
J
M
P
A
N
D
C
B
E
H
G
F
L
K
J
M
P
CAN J1939
( Optional )
Accessory
Input
Droop
Idle
Variable Speed / Trim
Potentiometer
120 Ohms
( End of CAN bus)
Ground to
Case
Ground to
Case
5KΩ
COM
VSPD
TermInal
DefInITIon
GaUGe / mm
2
noTeS
A
Actuator (+)
16 / 1.31
B
Actuator (-)
16 / 1.31
C
Magnetic Pickup (+)
20 / 0.52
* Twisted wires 14 turns per foot. 0.02in (.51mm) gap between sensor and gear teeth.
D
Magnetic Pickup (-)
20 / 0.52
E
Battery (-)
16 / 1.31
F
Battery (+)
16 / 1.31
A 15 amp fuse must be installed in the positive battery lead to protect against any over-
load or short circuit
G
Speed Switch (SSW
)
Speed switch relay; normally open (nO) or normally closed (nC)
H
Ground Signal
16 / 1.31
Reference for variable speed/trim input & switches
J
Variable Speed Input
20 / 0.52
5K Ω Resistive, 0-2.5 V DC or 4-20 mA. Increasing voltage or resistance of current
increases speed.
K
Droop Select
16 / 1.31
Active when connected to Terminal H
L
Idle Select
16 / 1.31
Active when connected to Terminal H
M
Aux Input
20 / 0.52
Load sharing / synchronizing, 5V nominal (0-10 V), configurable polarity
N
CAN L
20 / 0.52
Twist wires 14 turns per foot.
P
CAN H
20 / 0.52
recommenDaTIonS
1.
Shielded cable should be used for all external connections to the EEG control. One end of each shield, including the speed sensor shield, should be
grounded to a single point on the EEG case.
2. Case should be grounded
5K
Ω
reSISTIve SPeeD TrIm PoT
0-2.5 v or 4-20 ma* varIaBle SPeeD InPUT
When installing controller be sure there’s a good connection between the case of the EEG6500 and the chassis
/ battery ground.
If EEG detects no input from the magnetic pickup, the EEG will set the actuator to 0V and set the speed to 0 RPM. The display
will flash the RPM along with the Warning Indicator. Parameters will be unchangeable.
*
4-20mA input requires an external 200 Ω resistor across Terminals H & J
ImPorTanT
