GABOR TM-SS2, User Manual, Page: 8 / 12

8
Note: Mounting hardware for attaching the bracket to concrete and masonry walls is
included. Consult a professional for attaching the bracket to other wall surfaces.
Warning! Make sure the concrete wall is solid and at least 8 inches (20 cm) thick. If the concrete exhibits cracks or other
defects, this may result in failure of the concrete anchors and cause serious personal injury or damage your display.
1. Place the wall bracket up to the location marked for your display, and use a pencil to mark the four drilling holes needed
for the concrete anchors. Use the included bubble level to make sure the bracket is level before drilling.
2. Use a 3/8-inch (10 mm) concrete drill bit to predrill the marked spots 2.4 inches (60 mm) deep, and then clean out the
debris from the holes.
3. Insert the concrete anchors into the predrilled holes, and use a hammer to tap the anchors into the concrete.
4. Attach the bracket to the wall by inserting the anchor screws through the washers and the wall brackets’ mounting
holes, and screw them into the anchors until secure. Use the wrench to further tighten the anchor screws, but do not
overtighten. Use the included bubble level to make sure the bracket is level.
Attaching the Wall Bracket to Concrete
2.4 in.
1. Lift your display up to the wall bracket, and hang the display from the top hooks of the brackets.
2. Tighten the display bracket’s screws, using a screwdriver.
3. Use the tilt tension knobs on both brackets to adjust the tension for the tilting mechanisms.
Tilt the display into the ideal viewing angle from -10° to 5°, and tighten the tilt tension knobs until secure.
W-A
4X
W-C
4X
W-B
4X
TM-SS2 / TILT ING
WALL MOUNT
/ SMALL
2
3/8-inch