Mounting the Display on the Wall Bracket
13
Warning!
Make sure the concrete wall is solid and at least 8 inches (20 cm) thick.
If the concrete exhibits cracks or other defects, this may result in failure of the
concrete anchors and cause serious personal injury or damage to your display.
1.
Place the wall bracket template up to the
marked locations and tape it to the wall.
Use the included bubble level to make
sure the template is level before drilling.
Use a pencil to mark the four drilling
holes for the anchor screws and then
apply a piece of tape over the marks.
2.
Use a 3/8-inch (10 mm) concrete drill bit
to predrill the marked spots 2.4 inches
(60 mm) deep, and then clean out the
debris from the holes.
3.
Remove the template, insert the
concrete anchors into the predrilled
holes, and use a hammer to tap the
anchors into the concrete.
4.
Attach the bracket to the wall by inserting
the anchor screws through the washers
and the wall bracket’s mounting holes, and
screw them into the anchors until secure.
Use the box-end wrench to further tighten
the screws, but do not overtighten.
5.
Attach the center cover and two end covers.
Wall bracket mounted to concrete, with correct
screw placement.
Important!
We recommend that two people perform this step.
1.
Make sure the two top nuts are attached and slightly loose. Lift your
display up to the wall bracket, and seat the display into the mounting
holes so that it hangs.
2.
Replace the bottom hex nut and then tighten all three hex nuts using
the box end wrench.
N
1X
