Page 2 of 2
Date 20-07-2019
STEP 3 :
To unflip the extension top parts, make sure the the support bar has been pulled to its maximum
lenght. Using the extension table top parts without the support bar may cause breakage on the table
hinge. To make sure the exten�on table part are stable, please adjust the leveller at the end of
support bar.
STEP 4 :
If the floor is uneven, please use the levelers located at the underside of the Leg, to do this li
ft
up
the table side that needs to be adjusted, turn the leveler un
ti
l adequate contact with the floor as
shown in
Detail 4
.
Detail 3
Detail 3
Detail 4
Detail 4
