11
EN
Programming the “Chrono” mode
a)
Setting the day of the week and time.
-
Enter into “Stand
-
by” mode and press the [
-] button at least 3 seconds.
-
On the upper part of the display the message “Set” will be displayed.
-
To set the day and time press the [+] button until the bottom part of
the display the message “Ted” is displayed
.
-
Press the [Prog] button to enter the editing mode.
-
The blinking arrow indicates the currently selected day, pressing the [+] /
[-] buttons the desired day can then be set. Press again the [Prog] button to
confirm the selected day.
-
The procedure for entering the time starts and the display shows the currently selected time. -
Hours: Use the [+] and [-] buttons to set the correct hour and confirm the selected value
pressing the [Prog] button.
Minutes: Same procedure as for the hours. Confirm the selected value by pressing the [Prog]
button.
-
At the end of the procedure, the thermostat returns into “Stand
-
by” mode.
b)
Setting the program for the “Chrono” mode
.
-
Enter into “Stand
-
by” mode and press the [
-] button at least 3 seconds.
-
On the upper part of the d
isplay the message “Set” will be displayed
.
-
To set the day and time press the [+] button until the bottom part of the
display the message “Prog” is displayed.
-
Press the [Prog] button to enter the editing mode.
-
The procedure starts with day 1, and the desired sequence can be
configured with the [+] and [-] buttons. For each hour of the day, it is
p
ossible to assign either the “Comfort” or “Eco” temperature.
o
Press the [+] button
to set the “Comfort”
temperature level for the current hour. (full
bar indication displayed).
o
Press the [-
] button to set the “Eco”
temperature level for the current hour.
(empty bar indication displayed).
-
Press [Prog] to confirm the entered configuration for
day 1, and repeat the same procedure for the
remaining 6 days of the week.
-
Press [Prog] button again when having finished the
programme of the 7 days. The display returns into
“Stand
-
by” mode.
Note:
In case of loss of power supply, the settings of the
“Chrono” mode remain stored in memory for a few minutes
.
KEY LOCK
It is possible to lock the buttons of the device to avoid inadvertent modifications
of the settings.
Press the [Prog] button for 3 seconds to lock all the buttons except the
[On/Off] button. The key-lock icon is activated on the display.
To unlock the buttons, press again the [Prog] button for 3 seconds.
The key-lock icon disappears on the display.
