Gabarron ADS 84, Installation Instructions And User Manual

Page: 7 / 16

7
INTRODUCTION
Storage heaters are designed to take advantage of the considerable economical benefits of any restricted hour electricity tariff.
The heaters consume electricity only during the off-peak tariff, but due to the highly efficient storage medium, give you a truly
economical 24 hours of comfort temperatures. Supply with 220-240V~.
Type
Input
(W)
Charge
(kWh)
Weight
(kg)
L x W x H
8.5 kg
brick
13 kg
brick
Nominal
charging
time
ADS 84 800 6.4 48 31.5 x 16.5 x 72.5 4 - 8 hours
ADS 124 1200 9.6 69 43 x 16.5 x 72.5 - 4 8 hours
ADS 168 1600 12.8 88 54 x 16.5 x 72.5 8 - 8 hours
ADS 208 2000 16.0 109 65 x 16.5 x 72.5 4 4 8 hours
ADS 2412 2400 19.2 129 76.5 x 16.5 x 72.5 12 - 8 hours
ADS 2812 2800 22.4 150 88 x 16.5 x 72.5 8 4 8 hours
ADS 3216 3200 25.6 169 99 x 16.5 x 72.5 16 8 hours
ADS 84 /14 450 6.3 48 31.5 x 16.5 x 72.5 4 - 14 hours
ADS 124 /14 675 9.4 69 43 x 16.5 x 72.5 - 4 14 hours
ADS 168 /14 900 12.6 88 54 x 16.5 x 72.5 8 - 14 hours
ADS 208 /14 1125 15.7 109 65 x 16.5 x 72.5 4 4 14 hours
ADS 2412 /14 1350 18.9 129 76.5 x 16.5 x 72.5 12 - 14 hours
ADS 2812 /14 1575 22.0 150 88 x 16.5 x 72.5 8 4 14 hours
ADS 3216 /14 1800 25.2 169 99 x 16.5 x 72.5 16 14 hours
The input control operates a highly sensitive thermostat which regulates the amount of heat stored.
The discharge is by convection heat which can be partially controlled by use of the output control. Please note that types
ADS 84 and ADS 84/14 are fully automatic with no output control.
It is important that the correct rating of heater is installed to provide the selected level of heat. This will ensure the best
possible running costs against other fuels.
To reduce transport problems, the heater casings and storage bricks are packed separately.
You should be aware that Storage heaters, when fully charged, can have high surface temperatures.
2. INSTALLATION INSTRUCTIONS
1.- Chose the right place to install the heater. It is necessary that a minimum clearance of 50 cm is allowed to ensure the best
heating results. Always maintain a minimum clearance of 50 cm from the heater to any combustible materials such as furniture
and curtains.
2.- Open the carton at the indicated side and fix the feet without removing the heater casing (fig 1). The screws are in the
accessories bag. Turn the carton upside down to allow the heater to stand on its feet and remove the carton. Check that it is
the correct model and that it is in good condition.
fig 1