background image

 

1. IMPORTANT INFORMATION 

 

The warranty of the storage heater will not cover any damage caused by the non observance of any of these 
instructions. 

 

This guide must be kept and given to any new user. 

 

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory 

or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction 
concerning the use of the appliance in a safe way and understand the hazards involved. Children must not play 

with the appliance. Cleaning and user maintenance must not be made by children without supervision. 

 

Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been 
placed or installed in its intended normal operating position and they have been given supervision or instruction 

concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years 
and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance. 

 

Children of less than 3 years should be kept away unless continuously supervised. 

 

Should the heater be moved and reinstalled it is essential that the work is carried out by a fully qualified 
technician. 

 

If during any installation the thermal insulation shows any sign of damage, it is necessary for the faulty part to be 
removed and replaced by an identical part. 

 

The use of storage heaters is forbidden in any area where there is a presence of gases, explosives or inflammable 
objects. 

 

Do not use this heater to dry clothes. Do not cover this heater or put objects in contact with it. 

 

Do not cover the air inlet and outlet grills. 

 

This  heater  should  be  switched  off  at the isolating switch before any repair  work  is  carried  out.  This  action 

should also be taken during the times of the year when heat is not required. 

 

Please check that the voltage in the rating label fits the power supply. 

 

The installation of the heaters must be carried out in such a way that each pole can be disconnected from the 
supply having a contact separation of at least 3 mm. 

 

The storage heater should not be installed just below an electrical socket. 

 

The appliance must be installed in such a way that it is impossible for anyone using a bath or shower, to touch 
the controls. 

 

The nominal charging time of this storage heater is indicated on its rating plate and must be controlled by means 
of a programmer. 

 

The installation must be carried out in accordance with the current electrical regulations. Should the heater be 

moved and reinstalled it is essential that the work is carried out by a fully qualified technician. 

 

This appliance must be earthed / grounded. 

 

After installation a survey of the first charging cycle should be carried out to ensure that the main input 
thermostat switches off. Ventilate the room during this first cycle. 

 

Before carrying out any work inside the appliance, the heater must be disconnected from the electricity supply. 

 

Never open a charged heater. 

 

To maintain stability, it is essential that the heater is placed on a level surface and care should be taken to avoid 

irregular surfaces, such as may result from carpets or tiled surrounds partially protruding under the heater. 

 

The presence in the air of particles of smoke, dust and other pollutants could, in time, discolour the walls and 

surfaces around the heater. 

 

CAUTION — Some parts of this product can become very hot and cause burns. Particular attention must be 
given when children and vulnerable people are present. 

 

WARNING:

 In order to avoid overheating do not cover the heater. 

 
 

 

The symbol on the product or in its packaging indicates that this product may not be treated as household 

waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and 

electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative 
consequences for the environment and human health, which could otherwise be caused by inappropriate waste 

handling of this product. For more detailed information about recycling of this product, please contact your local city office, 

your household waste disposal service or the shop where you purchased the product. These instructions are only valid in the 
EU member states. 

Summary of Contents for ADS 124

















Reviews: