9600-0306.
Installation and User Instructions for S813 Readers,
Issue 1.5 17TH April 2012. G4S Technology, 2009. G4S
Technology Limited cannot be held liable for technical and editorial
omissions or errors made herein; nor for incidental or
consequential damages resulting from the furnishing, performance
or use of this material. All trademarks acknowledged.
FCC Notice:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
Any unauthorized modification to this device may void the
©
5
Using the Reader
3
Reader Connections
Specifications
Input: 310mA max @ 10-14Vdc.
Operating temperature: 32 to 122 F (0 to 50 C).
Operating humidity: 15 to 90%, non-condensing.
Maximum read range: 1" (25mm).
Approvals: EN301489, EN 302291.
For internal use only.
°
°
Present the proximity card face-on close to the reader underneath the finger pad until you hear a
"bleep". (No bleep is given if the audio feedback link, LK1, is in the "0" position.)
After presenting your card, you may be prompted to enter a PIN and/or place your finger on the finger
pad. Follow the on-screen instructions. For DESfire cards, you may also be prompted for a "CARD PIN".
If so, enter the DESfire card PIN, then press "#" if the PIN has fewer than eight digits.
The system can be set up to generate a "duress" transaction if the pre-defined duress finger is placed
on the pad. In two-finger mode, the duress finger must be placed first.
If the reader needs to read both MIFARE and MIFARE DESfire cards, make sure that one of each card
is presented to the reader immediately after the reader has been installed and the cards have been
encoded in the Admin/Card Holders screen of the SMS software. The reader supports the first two card
formats presented. If the two cards are the same type, only one format is supported.
A reader Setup menu can be displayed by pressing the * and # keys simultaneously while power is
applied. You can use the menu to change the language used for the LCD (default English), and view
the two card types/formats previously programmed. At the prompts, press * for No and # for Yes.
4
Reader Configuration
0V
RX+
RX-
TX+
TX-
12V
Reader
Controller
connections
(20mA current
loop)
0V
TX+
Do not use
TX-
RX+
RX-
+V
IT IS ESSENTIAL TO PLACE EACH FINGER
FLAT AND STRAIGHT ON TO THE SENSOR.
Slide your finger into place, so that your finger
makes contact with the ridge lock before the
sensor. The first joint of your finger must rest on the
ridge lock.
For further details of using this reader, refer to
the
813 Fingerprint Reader User's Guide
.
INCORRECT
û
CORRECT
ü
Ridge lock
Connect Shield at the controller
end only (attach to case).
Twisted pairs (use
Belden 9503 cable)
